Correct operation of spring chuck

Spring Collet is often used as a unique structure, a spare part. When using, put the chuck into the pressure cap first, and rotate the clip with fingertips. When the part of the shaft of the pressing cap is depressed in the groove of the retaining ring, evenly exert force along the direction of the arrow to promote the snap ring, and the cone can fall off. Therefore, the chuck only needs to move the sliding sleeve, so that the drilling and tapping sleeves can be exchanged quickly.

When drilling, the Morse sleeve is aligned manually; when tapping, the torque overload can stabilize the tire burst and prevent the tap from falling off. In addition, when changing the tool, use a wrench to loosen the pressure cap, take out the collet and the cutter, put down the cutter, and push the snap ring with force along the arrow direction to make it dissolve, and then replace the retaining ring with other apertures as required.