Er collet torque can smoothly slip and prevent wire breakage

Processing method of ER COLLET: first, pour the collet into the pressing cap, gently operate the circlip, when the eccentric part of the pressing cap is concave into the groove of the circlip, evenly force the circlip along the direction of the arrow, and then the cone will break. As long as the ER Collet moves the sliding sleeve, it can change the drilling and tapping sleeve safely. When drilling, the Morse sleeve is found automatically; when tapping, the torque carrier can slip smoothly to prevent the tap from breaking. In addition, when changing the tool, use a wrench to loosen the pressure cap to lead out the collet and the tool, remove the tool, force the circlip along the direction of the arrow to close it, and then replace the circlip with various apertures as required. The adjustability of the first mock exam of ER chuck is usually based on bolt tightening and pin position, when the fixture is coordinated and clamped, the length of a module can be lighter.

The clamping force ratio of Er Collet is larger, in addition, the clamping area is wider, and it also has higher precision. Therefore, it is widely used in a profession, such as in the machine tool profession. Compared with ER collet, it will have different types, and different collets are used in different biases. It has a high precision, can put the workpiece in a safe position, which plays a key role in the smooth processing of goods, and also enhances the production efficiency of goods. Er chuck should pay attention to the overall maintenance of the decoration, which directly affects the overall quality of the goods, with the emphasis on rust protection. Therefore, it is very important to select a suitable, high-quality and standard lubricating oil. Er collet is a kind of software which can't be replaced in machine tools nowadays. Its application area is very common, but it's safe but easy to be damaged. Because of this, the consumption is huge. The ER chuck follows different materials, and the methods of heat treatment are different. The hardness requirements of each position of the relative Er chuck are different.