Several requirements for prolonging the service life of spring collet

The spring chuck is a positioning device for prefabricated components that must be reformed for maintenance and engineering reinforcement. In the ordinary maintenance, the lathe spindle and the collet cone can be installed on the spindle bearing only after they are removed as far as possible. After application, the main body and pipe hoop should be removed clean and tidy, and rust proof, to ensure the smooth operation at that time. The following problems must be paid attention to in the maintenance of Spring Collet:
The spring chuck is a positioning device for prefabricated components that must be reformed for maintenance and engineering reinforcement. In the ordinary
1. Before installing the main cone of the main shaft bearing, clean the cylinder collet cone and lathe main shaft, and use a rubber material hammer or mallet to slowly impact the internal thread of the body to ensure that it is closely connected, firm or tightened according to the engine crankshaft.
2. Before production and manufacturing, according to the specific production and manufacturing regulations, it is necessary to remove the sediment in the relative sleeve, put it into the main thread, push the main sliding cover lightly, make the sleeve square into the main inner square hole, and then clamp the relative numerical control tool on the sleeve, so as to produce, manufacture and use.
3. If you use the tapping effect, do you remember to let go of the nut first, and tighten the nut according to the takeout with different torque specifications, so that the tap cannot be dragged.
4. When putting the tap into the tap sleeve, pay attention to put the four corner remote rod into the four corner hole edge of the welding fixture to improve the torque.
5. Slowly push the sliding cover, first remove the sleeve (or dismantle), and then remove the rust, main body and cylinder clamp.

Spring collet is a kind of positioning equipment, which is used for maintenance and engineering reinforcement. In the ordinary maintenance, the lathe spindle and the collet cone can be installed on the spindle bearing only after they are removed as far as possible. After application, the main body and pipe hoop should be removed clean and tidy, and rust proof, to ensure the smooth operation at that time.