ER collet chuck can smooth and prevent wire breakage when loaded with torque

ER chuck processing method: First, the chuck is poured into the pressure cap, and the clamp spring is gently operated. The eccentric part of the pressure cap is recessed into the clamp spring groove. The clamp spring is evenly and forcefully clamped along the arrow direction, and the cone is broken. As long as the ER chuck is a movable slipper, the drilling and tapping sleeves can be safely replaced. When drilling, the Mohs sleeve is found automatically; when tapping, the load of the torque can slip smoothly to prevent the tap from breaking. In addition, when changing the cutter, use the wrench to relax the pressure cap to draw out the chuck and the cutter, remove the cutter, and force the clip spring along the arrow direction, so that it can be closed, and then replace the clip spring with various apertures according to the need. The adjustability of ER clamp is usually decided by the way of bolt fastening, pin position, coordination and fixture installation, which can make the length of a module shorter.

The clamping force ratio of ER chuck is larger, the clamping area is wider, and it has higher precision. Therefore, it is widely used in a profession, such as machine tool profession. Compared with ER chuck, it has different kinds, but the example chuck is applied in different bias. It has a high precision, can work safely in a certain location, for the smooth processing of goods played a key role, and also enhanced the efficiency of the production of goods. ER chuck should pay attention to the overall maintenance of decoration, which directly affects the overall quality of goods, focusing on the protection against rust. Therefore, it is particularly important to select a suitable, high-quality, standard lubricating oil. ER chuck is common in machine tools, which is not replaceable at present. Its application area is very common, but its safety is easy to be damaged, because the consumption is huge. ER chucks follow different materials, the heat treatment methods required are different, the relative hardness requirements of each location of ER chucks are different.