Non-standard collet chuck can improve the position and length of shaft

What capability does the non-standard COLLET CHUCK acquire?

Non-standard collet chucks are made of high-quality alloy steel with good elasticity, and heat treatment makes the outer cone of the head and the inner wall of the chucks have high hardness to ensure firmness and high wear resistance. The non-standard collet chucks of each specification can clamp the workpiece in a small size environment, so they are mostly used in safety automatic machine tools such as automatic lathes. Non-standard collet chuck group has more real structure, good rigidity, can suffer greater torsion, eliminate the loosening phenomenon in operation, use special effective performance of alloy steel quality, good durability, strong durability, non-standard collet chuck used as an elastic component in the machinery and construction industry, springs should be able to produce a lot of elastic deformation under load. Mechanical work or power turns to form deformation energy, and after unloading, the deformation of spring disappears and returns to its original state.

collet

Non-standard collet chuck is a very simple commodity, but there is no reason to affect her basis. The ratio of friction between commodities clamped under ordinary gas mines and chucks is an important factor affecting whether the chucks are clamped or not. In general, the greater the friction force, the tighter the clamp, the smaller the friction force, the opposite.
First of all, we can only improve the efficiency of the big axle and the small axle. Our ability shows great clamping force. Because the clamping force of the big axle is very large compared with that of the small axle, the clamping force of the small axle is relatively small. Therefore, the improvement of the position and length of the good axle is often the key, and the commodity is too small and the clamping is not a common form.