CAT Lathe Chuck Face Mill Arbor

CAT Lathe Chuck Face Mill Arbor ,Cat Face Milling Holder The positive benefit to shorten the processing time, increase production per unit of time，the overall product precision, appearance quality，the production cost can be reduced.CAT Face Milling Holder used in the clamping of the cutter with the radial drive groove, such as the Face Milling Cutter, the vertical disc cutter, the set type end mill, high speed and high precision machining .

CAT Face Milling Holder The cutter bar requirements are as follows:
To be clamped tighter, better rigidity, small deflection accuracy of machining tool, in this case, can the effectiveness of potential play!
CAT Face Milling Holder The cutter bar check the accuracy of the matters needing attention:
1, the accuracy of the accuracy and reliability of the scale, the unit of measurement of at least 0.002mm.
2, the main test bar according to international standard
3, the accuracy of the tungsten steel mold qualified. Control shaft diameter tolerance within H6.
4, the cutter bar in the front, thoroughly clean all parts, such as the Collet Nut etc.. And at the same time, should pay attention to the cleanliness of the machine spindle.
5, the cutter bar clamping tungsten steel mold bar, the need to comply with all kinds of tool rod device description of. In order to avoid clamping precision caused by improper, distortion.
6, if the measurement. 180 degree deviation, the reason may be the bolt head or mechanical spindle taper precision etc..

CAT Face Milling Holder