Specification for use of hydraulic CNC tool holder?

Those who know something about CNC tools should know several tool handles and basic tools. However, for the detailed classification of knife handles and the advantages and disadvantages of each big knife handle, I believe you should not know so comprehensively. Let's introduce it to you. What should be paid attention to in hydraulic NC TOOL HOLDER?

1. When the hydraulic knife handle is pressurized, use a T-wrench to fully tighten the bolts

When the bolt is fully tightened, it will stop rotating. The hydraulic holding force of our hydraulic knife handle plays a better role when the bolt is fully tightened.

2. When the cutting tool is installed on the hydraulic tool handle, one end of the tool shall be close to the lower end of the hydraulic tool handle.

If one end of the cutting tool is too short to be close to the bottom inside the hydraulic tool handle, the position of one end of the cutting tool shall not be more than 8mm away from the bottom inside the tool handle during tool loading. (otherwise, the inner diameter of the tool handle will shrink and be damaged, and the tool handle will leak oil)

3. Before installing the knife on the hydraulic handle, remove the moisture, moisture (oil), etc. inside the handle.

The tool is loaded directly because the inside of the tool handle is not cleaned. During processing, the cutting tool will fall off due to the liquid foreign matter in the tool handle. (clean the inside of the tool handle before installing the milling cutter)



4. Do not open or pull the hydraulic hole on the hydraulic knife handle at will.

After the hydraulic hole is opened or pulled at will, it will lead to the loss of hydraulic oil, and the hydraulic knife handle will not be able to continue to be used and maintained.

5. Do not install rough cutting tools,

6. When the screw part of the tool handle is damaged or the hydraulic pressure cannot be processed normally and needs a / s maintenance, do not disassemble the tool handle by yourself. Please contact the supplier of shenganbei.

When selecting the NC Tool Holder, the size of the NC tool holder should adapt to the surface size of the workpiece to be processed. In production, end milling cutter is often used to process the peripheral contour of plane parts; When milling the plane, carbide blade milling cutter should be selected; When machining bosses and grooves, select high-speed steel end milling cutter; When machining rough surface or rough machining hole, corn milling cutter with cemented carbide blade can be selected; Ball end milling cutter, ring milling cutter, conical milling cutter and disc milling cutter are often used for the machining of some three-dimensional profiles and variable angle profiles.