Non-standard er collet chucks need to be selected for matching use

The production method of non-standard COLLET CHUCK: first, the chuck is poured into the pressure cap, and the clamp spring is run gently. Then the eccentric layout of the pressure cap is concaved into the clamp spring groove, and the clamp spring is propelled symmetrically along the arrow direction, so that the two halves of the cone can be coned. The ER chuck can make the drilling and Tapping Sleeves communicate at high speed only by turning to the sliding sleeve. When drilling, the Mohs sleeve is found automatically; when tapping, the load of the torque can slip smoothly, avoiding the two halves of the tap. In addition, when changing the cutter, release the clamp and the cutter with the wrench, remove the cutter, push the clamp spring along the arrow direction to make it tight, and then replace the clamp spring with other aperture according to the restriction. The adjustability of the non-standard chuck structure is usually selected according to the way of bolt fastening and pin position, when coordinating and fixing fixtures, the length of a module can be grinded more slowly.

The clamping force ratio of non-standard collet chucks is relatively large, in addition, the clamping field is relatively wide, and also has a low reliability. Therefore, it is widely used in the same light industry, such as in machine tool light industry. For ER COLLET chucks, it has different categories, and different types of chucks are applied to different biases. It has a very low reliability, and can position the components at a high speed in a certain position. It has played an important role in the smooth production of the instructions, and also enhanced the efficiency of the instructions. Non-standard chuck should pay attention to the surface maintenance of decoration. It directly affects the surface quality of the instructions. The core is to prevent corrosion. Therefore, it is very important to select suitable, high-quality and specialized lubricants. Non-standard Collet Chuck is common in machine tools, which is irreplaceable software at present. It is especially common in the field of use. It is fast but easily damaged, so the consumption is huge. Non-standard collet chucks follow different resources, and the limited heat treatment methods are also different, and the density requirements of different parts of non-standard collet chucks are also different.